Technical Support : 91520 10269 : indiatechsupport@texe.com
Connecting Keyfob
Power
Arm
Part arm
Disarm
LED Status
Disarm
alarm
Status
led
Arm alarm
Status led
Part arm
alarm
Status led
Press 1234 on the control panel. The below
message will be displayed.
Press 8 to reach “Setup Users”
Press Yes (Will show you the free User as below)
Press arrow button ( or ) to select the required User
Press Omit button ( ) to select the required User
Press No button ( X ) it will start learning process
During this learning process you need to power on the keyfob by holding the
power button for 4 seconds. once the device is learned will show as below.
Press Menu ( ) three times on the control panel and then press Yes to logoff
from your control panel
Note: In this example, we selected
Master user
Premier Elite SmartKey (GCC0012)
To Next Page
Need help?
General
