texet DVR-3GP - Page 8

Loop recording does
not work,
loop recording stops
Wrong parameter setting
are installed, the card
is lled with «heteroge-
neous les», exceeded
amount of locked les
up to g-sensors, memo-
ry card fault.
- Set «loop recording»
mode in 5, 10 or 15 min-
utes - depending on the
capacity of the card;
- Format the card in the
recorder;
- Test card for broken
sectors using auxiliary
software.
Sound problems:
hiss, too silent, too
loud, extraneous
sounds
Multiple devices con-
nected to one adapter,
untightly attached
mount, low-quality
power adapter.
- Use the power adapter
supplied;
- Rex the mount to the
windshield, as well as to
the mount connector of
the device;
- Connect different
devices to the different
supply chains.
Distorted colors in
video
«White balance» fault,
display fault.
- Set the white balance
to «auto» mode;
- Contact the service
center.
Device does not
charge through
USB-cable
Damaged USB-cable,
defective connectors,
unsuitable USB-cable.
Current supplied to the
PC USB-port is not suf-
cient for the standard
battery charging.
Replace the USB-ca-
ble, charge the device
through the car charger.
Try to insert the USB-ca-
ble into a different PC
USB-port; do not use
external PC USB-port
for the battery charging,
which may not provide
the required charging
current standard for
battery charging, charge
the battery through the
car charger.
ENG
7
DVR.indd 7 16.01.2014 13:31:32