Keep the submersible motor vertical
Apply threading compound to internal thread on the delivery casing and external threaded
portion of the short length delivery pipe to be fitted to the delivery casing
Screw the short length of delivery pipe to the delivery casing
Locate the pump key in pump shaft keyway
Carefully lower pump in such a way that the pump shaft is inserted into the coupling while
ensuring that pump shaft key is aligned with keyway in the coupling
Ensure that studs on the motor should pass through the holes in the bottom portion of the inlet
bracket and that the face of inlet bracket rests on top of the motor seating face
Using hexagonal nuts, tighten inlet bracket to cable box of the motor
Check the play by lifting the coupling with pump shaft.
Now fit the cable guard and strainer back in position.
Refer Fig. 9 below for coupling the submersible motor to the pump:
Fig. 9 Motor and Pump assembly with Coupling
Pump Key
Coupling
Strainer
Inlet Bracket
Motor Key
Cable Box
Sand Guard
OMBW004A 22 2020 .01
To Next Page
Loading...
