CESSNA SECTION 8
MODEL 208B 867 SHP AIRPLANE HANDLING, SERVICE
GARMIN G1000 AND MAINTENANCE
U.S.
FUEL (Continued)
FUEL ADDITIVES (Continued)
PROCEDURE FOR ADDING FUEL ANTI-ICING ADDITIVE
When the airplane is being refueled, use the following procedure to
blend anti-icing additive to nontreated fuel:
1. Attach additive to refuel nozzle, making sure blender tube
discharges in the refueling stream.
2. Start refueling while simultaneously fully depressing and slipping
ring over trigger of blender.
Anti-icing additives containing Ethylene Glycol
Monomethyl Ether (EGME) are harmful if inhaled,
swallowed, or absorbed through the skin, and will
cause eye irritation. It is also combustible. Before
using this material, refer to all safety information on
the container.
• Diethylene Glycol Monomethyl Ether (DIEGME) is
slightly toxic if swallowed and may cause eye
redness, swelling and irritation. It is also
combustible. Before using this material, refer to all
safety information on the container.
• Make sure the additive is directed into the flowing
fuel stream with the additive flow started after the
fuel flow starts and stopped before fuel flow stops.
Do not allow concentrated additive to contact coated
interior of fuel tank or airplane painted surface.
• Use a minimum of 20 fluid ounces of additive per
156 gallons of fuel and a maximum of 20 fluid
ounces of additive per 104 gallons of fuel.
(Continued Next Page)
208BPHCUS-00 8-23
To Next Page
Loading...
