STEERING
4181383 First Edition 7-13
7
1. Inspect the springs (9 and 13) for bent, broken, or
distorted coils.
Always replace springs as a set.
2. Inspect the finished ground surfaces of all the
components.
3. Inspect the slot edges and surface for nicks, scoring,
and rounding edges.
NOTE
The valve ring (11) and valve plate (12) are a
matched set and are not serviceable.
4. Inspect the hex drive (15) for wear.
5. Inspect the isolation manifold (16) for nicks,
scratches, and scoring. A polished wear pattern due
to valve plate rotation is normal.
6. Inspect the drive link (18) for wear and damage.
7. Inspect the thrust bearing (33) for dents, spalling,
and missing rollers.
8. Discard all seals and seal rings.
9. Inspect the commutator cover (24) and drive plate
(31) for wear and damage. A polished wear pattern is
normal.
Figure 7-14
10. Inspect the rotor (45) and stator (46) fit for wear and
damage.
11. Install rotor in stator and center the rotor lobe (47)
across from a lobe to be measured (44). Measure
rotor (45) and stator (46) fit for maximum trip
clearance of 0.003 in. (0.08 mm).
Assembly
See Figures 7-15 through 7-18.
45
46
44
47
TN1391
Service Part Kits
Seal Kit (Jacobsen P/N 557738)
Metering Assembly Kit (Jacobsen P/N 5003220)
Spring Kit (Jacobsen P/N 502924)
Jacket Tube Kit (Jacobsen P/N 5003219)
Needle Roller Kit (Jacobsen P/N 502925)
To Next Page
Loading...
