HYDROSTATIC POWER TRAIN
4252490-Rev A 5-59
5
Installation Notes
• Install rear wheel motor by reversing the order of
removal.
• Tighten rear wheel motor mounting screws (6) to 59–
66 lb-ft (80–90 N·m).
• Tighten inlet and outlet port fittings (4 and 5) to 77
lb-ft (105 N·m).
• Pressure filter the traction system upon start-up if
metal debris is found in system oil or motor. (See
“Portable In-Line Filter” on page 5-5.)
• Check hydraulic oil level. Add oil as needed. (Refer
to “Parts and Maintenance Manual” for correct oil
specifications.)
To Next Page
Loading...
