STEERING
4252490-Rev A 7-9
7
Figure 7-14
3. Remove four screws (7) and washers (6).
NOTE
Mark the location of the special screw before removing to
ensure correct installation.
4. Remove special screw (10) with nut (8) and washer
(9).
5. Remove end cover (5).
Figure 7-15
NOTE
The gearwheel to distributor plate is a tight fit. Tap the
side of the gearwheel rim with a soft-faced hammer to
loosen.
6. Remove the gearwheel rim (11), gearwheel (13), and
two O-rings (12 and 14) as a unit, keeping the
gearwheel and gearwheel rim in the same orientation
to each other.
Figure 7-16
NOTE
The distributor plate to housing is a tight fit. Tap the side
of the distributor plate with a soft-faced hammer to
loosen.
TN3919
6
7
5
9
8
10
TN3922
11
12
14
~
13
TN3923
16
15
To Next Page
Loading...
