Textron JACOBSEN GP400 - Page 264

7-10 4252490-Rev A
STEERING
7
7. Remove two sleeves (15).
8. Remove distributor plate (16).
Figure 7-17
9. Remove O-ring (17) from housing (2).
10. Remove cardan shaft (18).
Figure 7-18
11. Remove spool and sleeve assembly (19) as a unit
from the housing (2).
Figure 7-19
NOTE
The spring retaining ring may remain inside the housing
when the spool and sleeve assembly is removed.
12. Remove spring retaining ring (22).
13. Remove spring set (21) from spool (20).
14. Remove cross pin (24) from spool (23) and sleeve
(20), and remove spool from sleeve.
Figure 7-20
15. Remove thin washer (27), thrust bearing (28), and
thick washer (29).
NOTE
Note the location of the check valve ball to ensure correct
installation.
16. Remove fixture from vise and shake out check valve
ball (26) from port “T.”
TN3924
17
18
2
TN3925
19
2
TN3929
20
21
23
24
22
TN3927
TN3927
26
25
2
27
28
29