STEERING
4252490-Rev A 7-13
7
Figure 7-26
14. Install two sleeves (18).
15. Install distributor plate (19).
Figure 7-27
16. Install a new O-ring (23) in the distributor plate side
of the gearwheel rim (20).
NOTE
\
When installing the gearwheel, the gearwheel must be
correctly aligned so that it engages with the cardan shaft.
17. Install gearwheel rim (20) and gearwheel (22) onto
the distributor plate, in the same orientation as noted
during removal.
18. Install a new O-ring (21).
Figure 7-28
19. Align end cover (24) to housing and install special
screw (28) with nut (27) and washer (29) into the
same location in the end cover as noted during
removal. Do not tighten at this time.
20. Install four special screws (26) and washers (25) into
the end cover (24). Do not tighten at this time.
21. Tighten screws in an alternating pattern to 20–24 lb-ft
(27–33 N·m).
22. Remove steering unit from the service fixture.
TN3923
19
18
TN3922
20
21
23
~
22
TN3919
25
26
24
29
27
28
To Next Page
Loading...
