Textron Jacobsen SLF530 - Page 180

5-54 673831-Rev A
HYDROSTATIC POWER TRAIN
5
23. Remove snap ring (8).
24. Release press force and remove inner roller
bearing—inner race installation tool.
NOTE
When removing shim spacer (7), measure and note the
thickness of the shim spacer.
25. Remove shim spacer (7).
Figure 5-57
26. Secure bearing support (4) to a suitable press fixture
(51) and position press fixture on supports (53) under
a press (52) with enough clearance to remove motor
shaft (1).
27. Remove motor shaft (1).
28. Remove roller bearing (6) and radial lip seal (5).
Figure 5-58
29. Install a bearing puller (54) under environmental seal
(2).
30. Remove environmental seal (2) and roller bearing
(3). Discard environmental seal.
1
4
51
52
53
MAR0109
2
3
54
MAR0110