60 SHB MPE850 Rev F | 408014 | 408090 | 408101 | 408246 |
6
7
10
9
8
► Unscrew the bolts
6
.
► Remove the valve cover
7
.
Information! The camshaft is turned by turning the crankshaft. Read the vehicle manufacturer‘s
documentation for instructions. Always turn the crankshaft in the same direction as the engine rotates.
(See chapter 3.6 Engine components and information.) Two rotations of the crankshaft correspond to one
rotation of the camshaft.
► Check the valve lash
10
of all valves on the
cylinder using a feeler gauge.
Required valve lash:
0,2 – 0,3 mm
► If the valve lash of one or more valves is not
right, continue with chapter 8.5.2 Adjusting
valve lash.
Checking valve lash on the 2nd cylinder
► Turn the camshaft until the position of the
camshaft is as illustrated. (See the vehicle
manufacturer‘s documentation.)
The camshaft is marked at the 2nd cylinder end
only.
The marking
8
ends flush with the cross
bar.
All rocker arms
9
on the cylinder have a
certain amount of play.
8 Service tasks in the workshop
8.5 Checking and adjusting valve lash
To Next Page
Loading...
