67SHB MPE850 Rev F | 408014 | 408090 | 408101 | 408246 |
10
9
7
8
6
5
11
The ignition coils must not be replaced always.
(See chapter 4.1 Service intervals.)
► Replace the ignition coils
6
.
► Insert the ignition coils.
► Replace the serrated lock washers
7
.
Assemble the bolts
8
, washers
9
and
serrated lock washers as illustrated.
Tightening torque:
8 Nm +2 Nm [5.9 lbf ft +1.5 lbf ft]
► Connect the wire harness connectors to the
ignition coils
10
.
► Touch up paintwork defects.
► Clear the service counter to reset service
light. (See the Textron Motors Diagnostic
Tool manual.)
► Update the engine control unit calibration.
(See the Textron Motors Diagnostic Tool
manual.)
8 Service tasks in the workshop
8.6 Replacing spark plugs and ignition coils
► Unscrew the spark plugs
5
using a spark
plug wrench.
► Replace the spark plugs.
► Screw in the spark plugs using a spark plug
wrench.
Tightening torque:
22 Nm +10 Nm [16.2 lbf ft +7.4 lbf ft]
► Attach and press down on the engine cover
11
until it snaps into place.
► Test-drive the vehicle.
To Next Page
Loading...
