87SHB MPE850 Rev F | 408014 | 408090 | 408101 | 408246 |
6
7
Filling with coolant
► Fill coolant to the expansion tank until the
MAX-marking
6
.
► Close the expansion tank.
► Warm up the engine. (See chapter 4.2
Operation during the break-in period.)
► Turn off the engine.
► Check the coolant level.
CAUTION! Scalding caused by hot steam. Open
expansion tank only with a cold engine.
NOTICE! Danger of overheating caused by a lack
of coolant.
► When coolant level is below the MIN-
marking
7
, wait until the engine has
cooled down.
► Refill coolant, until the coolant level is
between the MIN-marking and the MAX-
marking.
NOTICE! Leaks in the hoses due to increased
pressure.
► When the MAX-marking is exceeded, pump
out excessive coolant with a suction pump.
► Touch up paintwork defects.
► Clear the service counter to reset service
light. (See the Textron Motors Diagnostic
Tool manual.)
► Update the engine control unit calibration.
(See the Textron Motors Diagnostic Tool
manual.)
► Test-drive the vehicle.
8 Service tasks in the workshop
8.11 Changing coolant
To Next Page
Loading...
