1
38 DHB MPE850 UTV Rev A | 409135 |
6 Test procedures at engine
6.6 Checking oil pressure
6.6 Checking oil pressure
► Warm up the engine. (See the
manufacturer‘s documentation.)
► Unscrew the switch oil pressure
1
.
CAUTION! Scalding caused by hot engine oil.
Wear protective gloves.
► Screw in the adapter M10x1 for oil pressure
tester according to the manufacturer's
instructions.
Tightening torque:
9 Nm +2 Nm [6.6 lbf ft +1.5 lbf ft]
► Start the engine and run the engine at idle.
► Measure oil pressure with oil pressure tester
according to the manufacturer's instructions.
Required oil pressure while idle:
Minimum 1,5 bar
Maximum 5,5 bar +0,5 bar
► Increase engine speed.
The oil pressure increases immediately.
Required oil pressure at 3000 min
-1
[RPM]:
Minimum 2,5 bar
Maximum 5,5 bar +0,5 bar
► Unscrew the adapter M10x1.
NOTICE! Loss of engine oil due to leaks. If you
have unscrewed the plug, the TufLock coating is
not completely effective any more.
► Apply Loctite 542 to the thread of the switch
oil pressure.
► Screw in the switch oil pressure.
Tightening torque:
9 Nm +2 Nm [6.6 lbf ft +1.5 lbf ft]
Information! Limited by the oil pressure valve the maximum oil pressure is 5,5 bar.
To Next Page
Loading...
