Textron MPE 850 OFF-ROAD - Removing Suction Pump Cover and Gear

27TD410023-B RLF
B
A
B
B B B
B
A
A
AA
B
A
A
2
1
4
1
2
3
4
3
ENGINE DISASSEMBLY
1. Turn the engine 180°.
2.
5 mm: Remove seven bolts M6x20
B
and
seven bolts M6x30
A
.
REMOVING SUCTION PUMP COVER
The suction pump cover is sealed with a silicone
liquid seal.
3. Lift off the suction pump cover at the joints
1
and
2
.
4. Remove the suction pump cover
3
.
5. Remove two sleeves
4
.
Observe in section C Additional working
instructions the chapters Suction pump cover
disassembly and Suction pump cover
reassembly.
MOUNT THE ENGINE ON THE DRIVE SIDE
1. Mount the engine on the drive side on the
engine stand.
Suitable mounting points M10:
– Screw-in depth
1
and
2
30 mm
Support:
– Minimum one mounting point M6
3
or
4
.
A