Textron MPE 850 OFF-ROAD - Removing Crank Drive

30 TD410023-B RLF
1
97 8
6
5
4
2
1
3
2
3
5
6
4
ENGINE DISASSEMBLY
REMOVING CRANK DRIVE
1. Turn the engine 180°.
Remove all bolts in the sequence as
illustrated
1
.
2.
5 mm: Remove four bolts M6
1
–
4
.
3.
6 mm: Remove five bolts M8
5
–
9
.
4. Remove the oil pressure valve
2
using a bar
magnet.
The crankcase is sealed with a silicone liquid seal.
5. Remove the lower case
3
.
6. When replacing a tie rod
4
, install the new
tie rod according to the specification Tie rods
M10x1.25. (See section D Tightening torques
und assembly instructions.)
Mark the cylinder assignment and installation
position on the piston, con rod, con rod cover and
bearing shells.
7.
12 mm: Remove four con rod bolts
5
.
8. Remove two con rod covers
6
.
A