40 TD410023-B RLF
6
8
7
ENGINE REASSEMBLY
6. When replacing a piston with con rod, check
the con rod bearing play according to the
specification Con rod bearing play. (See
section D Test procedures and adjustments.)
7. Coat four con rod bearing shells
5
lightly
with engine oil and insert in the con rods and
con rod covers. (See the following assembly
instructions for con rod bearings.)
ASSEMBLY INSTRUCTIONS FOR CON ROD
BEARINGS
NOTICE! Serious bearing damage caused by
incorrect installed con rod bearing shells.
► Insert two con rod bearing shells
1
centered on the con rod.
► Measure wether the dimensions "="
2
are equal.
8. Coat the piston
6
lightly with engine oil.
9. Arrange the piston ring gaps. (See the
following assembly instructions for piston ring
gaps.)
The arrows on the pistons mark the installation
position of the pistons in the engine. When the
pistons are installed in the engine, the arrows point
towards the chain tensioner
7
and the
starter
8
. (See the following assembly
instructions for pistons.)
10. Insert the piston using a piston ring
compressor.
11. Repeat the procedure with the other piston.
To Next Page
Loading...
