Textron MPE 850 OFF-ROAD - Installing Oil Pressure Pump

50 TD410023-B RLF
14
13
15
x
2
1
7
3
4
5
6
8
ENGINE REASSEMBLY
11. 7 mm: Remove two bolts
15
.
12. Remove the guiding sleeve
13
.
13. Check if the oil seal
14
is tilted.
14. If the oil seal is tilted, it must be replaced.
INSTALLING OIL PRESSURE PUMP
NOTICE! Engine damage caused by lack of
lubrication. If the timing insert is installed in reverse
direction, the engine cannot build up any oil
pressure. Insert the side with centering pin
1
first.
1. Insert the timing insert
2
. Observe the
installation position.
NOTICE! Engine damage caused by lack of
lubrication. If the key
3
is not installed, the
engine cannot build up any oil pressure. Always
install the key.
2. Replace the key.
3. Insert the key.
4. Insert the inner rotor
4
of the oil pressure
pump.
5. Insert the outer rotor
5
of the oil pressure
pump.
6. Replace two o-rings
6
and lightly coat with
petroleum jelly.
7. Insert the oil pump cover
7
.
WARNING! Serious eye injuries caused by a
fast hurled circlip. Wear protective glasses.
8. Install the circlip
8
using a lockring pliers.
B