Textron MPE 850 OFF-ROAD - Installing Crankshaft Sensor and Cover

52 TD410023-B RLF
1
2
3
4
1
2
3
4
1
ENGINE REASSEMBLY
MOUNT THE ENGINE ON THE DRIVE SIDE
1. Mount the engine on the drive side on the
engine stand.
Suitable mounting points M10:
– Screw-in depth
1
and
2
30 mm
Support:
– Minimum one mounting point M6
3
or
4
.
INSTALLING CRANKSHAFT COVER
1. Replace the gasket
1
and lightly coat with
petroleum jelly.
3. Insert the sensor
4
.
4.
4 mm: Install the bolt
3
according to the
specification Other bolts M6 Standard. (See
section D Tightening torques und assembly
instructions.)
1. Replace the o-ring
2
on the sensor and
lightly coat with petroleum jelly.
2. If a sleeve is installed on the sensor, slide the
o-ring up to sleeve
1
.
or
If no sleeve is installed on the sensor, slide the
o-ring to the illustrated distance.
INSTALLING CRANKSHAFT SENSOR
B