Textron MPE 850 OFF-ROAD - Intake Manifold Reassembly; Installing Intake Manifold Sensor; Installing Throttle Body

66 TD410023-B RLF
4
3
1
2
1
2
1
ADDITIONAL WORKING INSTRUCTIONS
3. Perform a visual inspection on the rubber
mount
3
.
An even edge
4
is visible.
1. Hold the rubber mount
2
in position.
Screw in the bolts evenly crosswise.
2.
5 mm: Install four bolts
1
according to the
specification Other bolts M6 Standard. (See
section D Tightening torques und assembly
instructions.)
INTAKE MANIFOLD REASSEMBLY
INSTALLING THROTTLE BODY
INSTALLING INTAKE MANIFOLD SENSOR
1. Insert the sensor
2
.
2.
T30: Install the bolt
1
according to the
specification Other bolts (self-tapping) 6x20.
(See section D Tightening torques und
assembly instructions.)
Only valid for engine model 409135 I2 846 UTV
NA-80.
1. Check if the cap
1
is installed.
C