8
Hydro
Midsize
20. Close bypass valve X by rotating clockwise until
rmly seated.
ASSEMBLY/SET-UP INSTRUCTIONS
19. Connect swivel on threaded end of brake rod
Q to the brake arm T and secure in place with
hairpin S as shown. Adjust swivel to provide
adequate braking when the brake control arm is
engaged. See adjustment section of this manual.
21. On Electric Start Models
Obtain battery locally.
Batteries come with acid. Check level and
charge before startup.
If necessary, ll the battery to the bottom of the
vent wells with electrolyte and trickle charge for
several hours. Place the battery in the machine
and make the connections, red to positive rst,
then black (ground) to negative. Install battery
cover BC and secure with battery rod and
attached hardware.
Batteries Produce Explosive Gases
- Keep sparks and ame away.
- Disconnect negative terminal rst.
- Reconnect negative terminal last.
To Next Page
Loading...
