22 DHB MPE850 UTV Rev A | 409135 |
5 Troubleshooting with trouble codes
5.2 Description of trouble codes
Trouble code
Displayed fault
Trouble code description
Possible consequences
Affected part/system
► Possible consequences/remedy
P0315 Crankshaft Position – Camshaft Position
Correlation - Gap Position Incorrect
The sensor crankshaft signal is undetermined.
Engine does not start.
Sensor crankshaft
► Check wiring in the wire harness to
the affected part. (See the vehicle
manufacturer‘s documentation.)
► Replace the affected part. (See the vehicle
manufacturer‘s documentation.)
► Check the crankshaft reluctor. (See
chapter 6 Test procedures at engine.)
P0325 Knock Sensor 1 Signal out of Range
The sensor knock signal is insufficient
Loss of power.
Sensor knock
► Check bolting of the affected part. (See the
vehicle manufacturer‘s documentation.)
► Check wiring in the wire harness to
the affected part. (See the vehicle
manufacturer‘s documentation.)
► Replace the affected part. (See the vehicle
manufacturer‘s documentation.)
P0326 Knock Sensor Range Error Sensor knock
► Possible consequences/remedy as
described for trouble code P0325.
P0336 Crankshaft Position Sensor Missing Signal
No signal at the sensor crankshaft.
Engine does not start.
Sensor crankshaft
► Check wiring in the wire harness to
the affected part. (See the vehicle
manufacturer‘s documentation.)
► Replace the affected part. (See the vehicle
manufacturer‘s documentation.)
P0341 Camshaft Signal Missing
No signal at the sensor camshaft.
The engine speed is limited.
Sensor camshaft
► Check wiring in the wire harness to
the affected part. (See the vehicle
manufacturer‘s documentation.)
► Replace the affected part. (See the vehicle
manufacturer‘s documentation.)
To Next Page
Loading...
