EasyManua.ls Logo

Textron Stampede 900 2017 - Page 211

Textron Stampede 900 2017
237 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23DHB MPE850 UTV Rev A | 409135 |
5 Troubleshooting with trouble codes
5.2 Description of trouble codes
Trouble code
Displayed fault
Trouble code description
Possible consequences
Affected part/system
Possible consequences/remedy
P0344 Camshaft Position Signal Timeout
During operation implausible signals occur at
the sensor camshaft.
Sensor camshaft
Check if the affected part is unusually dirty.
Check the cam spike at rocker arm. (See
chapter 6 Test procedures at engine.)
Check wiring in the wire harness to
the affected part. (See the vehicle
manufacturer‘s documentation.)
Replace the affected part. (See the vehicle
manufacturer‘s documentation.)
P0351 Ignition Coil 1 Control Circuit Low/Open
Open circuit or short circuit to ground at part or
wire harness.
Rough engine running.
Engine does not start or stalls.
Ignition coil 1st cylinder
Check wiring in the wire harness to
the affected part. (See the vehicle
manufacturer‘s documentation.)
Replace the affected part. (See the vehicle
manufacturer‘s documentation.)
P0352 Ignition Coil 2 Control Circuit Low/Open
Open circuit or short circuit to ground at part or
wire harness.
Rough engine running.
Engine does not start or stalls.
Ignition coil 2nd cylinder
Check wiring in the wire harness to
the affected part. (See the vehicle
manufacturer‘s documentation.)
Replace the affected part. (See the vehicle
manufacturer‘s documentation.)
P0370 Crankshaft Position Signal Spike Detected
Erratic signal at the sensor crankshaft.
Engine does not start.
Sensor crankshaft
Check wiring in the wire harness to
the affected part. (See the vehicle
manufacturer‘s documentation.)
Replace the affected part. (See the vehicle
manufacturer‘s documentation.)
P0372 Crankshaft Position Signal Teeth Missing
Erratic signal at the sensor crankshaft.
Engine does not start.
Sensor crankshaft
Check wiring in the wire harness to
the affected part. (See the vehicle
manufacturer‘s documentation.)
Replace the affected part. (See the vehicle
manufacturer‘s documentation.)

Table of Contents

Related product manuals