Textron Stampede 900 2017 - 6 Test Procedures at Engine; 6.1 Checking Voltage Regulator

33DHB MPE850 UTV Rev A | 409135 |
600 mm [23.7 in]
200 mm [7.9 in]
A
B
A
B
C
NX2
NX1
NX3
N1
6 Test procedures at engine
6.1 Checking voltage regulator
6.1 Checking voltage regulator
6 Test procedures at engine
N1 Voltage regulator
NX1 3-pole connection at
stator generator (yellow
wires)
NX2 2-pole connection at
battery cable (red wires)
NX3 Connection engine
ground inner diameter
8 mm (black wires)
► Check all electrical contacts for corrosion and proper mechanical connection.
► Make a diode test with all relevant wires:
Diode test with multimeter: Cross checking:
Diode tester probe Diode tester probe
Plus (red) Ground (black) Test result Ground (black) Plus (red) Test result
NX2-A NX1-A No continuity is
permitted
NX2-A NX1-A Continuity is
required
NX1-B NX1-B
NX1-C NX1-C
NX2-B NX1-A NX2-B NX1-A
NX1-B NX1-B
NX1-C NX1-C
NX3 NX1-A Continuity is
required
NX3 NX1-A No continuity is
permitted
NX1-B NX1-B
NX1-C NX1-C
► If the wires are defective, replace the voltage regulator.