OPERATING AND ASSEMBLING MANUAL
-(Fig.I) One-time attachment of the holding fixtures
Attach the holding fixtures (1) from underneath the rear axle of
the buggy. Make sure that the attachments are mounted
above the braking distributer. Pay attention to the arrows,
which should be pointing in the driving direction, as well as the
labels ‚L‘ for left and ‚R‘ for right facing the driving direction.
Then you can insert both holding brackets (2) from above into
the holding fixtures and attach them with two screws (3) on
the underside
-(Fig.II)
Use the adapters (4) to attach the Mamaboard to the holding
fixtures (5) until they audibly click into place. If you would like
to remove the Mamaboard, push the locks (5) back.
-(No illustration)
When you are not using the Mamaboard, you can clap it
up and attach it with the pin on the underside of the
board to the transportation security belt.
To Next Page
Loading...