31
D. Procedure to Release Air
(1) Apply suitable plastic tube on drain plug,
and put a tray under drain hole.
(2) Slowly apply front brake several times.
(3) Hold the front brake lever, and do not
release the brake lever.
(4) Unplug the air release plug, and still hold the
brake lever.
(5) Tighten the air release bolt, then release the
brake lever.
(6) Repeat procedure 1 to 5, and release
air/bubble completely.
Note: Torque of air release bolt: 60 kg-cm.
E. Front Brake Disk
Inspection: If there is scratches, damage, or
wear, please replace with new one.
Note: The minimum disk thickness: 3.0 mm.
To Next Page
Loading...
