Using the right tool can make assembling your models easier and it can also make
your models work better in the end. It is best to cut the plastic parts out of their
frames with a small diagonal cutter (such as those used for electronics work) or
model pliers. Using these tools, the parts can be precisely cut so that no burrs
remain on the parts and there is no need to file them down.
If you don’t have these pliers at home, you can use scissors and a nail file.
Normal scissors do not cut as precisely as a diagonal cutter, so you may
have to file some of the rough edges down with the nail file.
THE RIGHT TOOL
2
SAFETY INFORMATION
Not suitable for children under 3
years. Choking hazard — small
parts may be swallowed or
inhaled. Keep the packaging and
instructions as they contain
important information.
Hold the built models as shown in
the instructions. When operating
the models, do not put your
fingers near the moving parts.
!
!
WARNING
To Next Page
Loading...
