EasyManua.ls Logo

The GigRig Pro-8 - Page 16

The GigRig Pro-8
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
All rights reserved. Design rights claimed. Moral rights asserted. Revised March 2010 Page 16
11. FAQ’S
Q. What’s the best order to put my effects in?
Answer:
The order that you place your effects makes a dramatic difference to your guitar
sound.
Do you phase your distortion or do you distort your phaser?
Of course, there are no set rules and with TheGigRig Pro-8, you can experiment as
much as you like. I’ve found the following to be a good place to start.
1
st
Envelope filters, auto wahs and wah pedals.
2
nd
Compression
3
rd
Overdrive, distortion and fuzz. (Use in order of the least amount of gain to the most)
4
th
Modulation effects (phase, chorus, flange, tremolo)
5
th
Delay effects (shorter delays, followed by longer delays)
6
th
Reverb
Q. How do I use TheGigRig Pro-8 with the effects loop in my amp?
Answer:
The effects loop in your guitar amplifier gives you an insertion point between your pre-
amp and your power amp for you to connect your effects.
With TheGigRig Pro-8, you can insert the pre-amp section of your amplifier into any
point in the signal chain.
E.g. Say I want my compression and overdrive pedals going into the front of the amp
and my modulation and delay effects in my amps effects loop, I would use the effect
loop that is after my overdrive and before my modulation effects. The send from
TheGigRig Pro-8 is plugged into the front of your amp and the effects send from the
amplifier is plugged into the return of TheGigRig Pro-8. What you’ve done is placed
your pre-amp where you want it in your signal path. The output of TheGigRig Pro-8
then goes to the return on your amplifier.
If you have 2 amps, each with their own effects loops you can actually choose which
pre-amp you send to which power amp!
Q. I have spilled my beer onto one of the micro-switches; it is now difficult to use or
faulty.
Answer:
Don’t panic, you don’t have to give up beer! All the micro-switches are in sockets and
can be easily replaced, without opening TheGigRig box. Take great care not to damage
the paintwork. See our web site for replacement parts.
Q. I would like TheGigRig to work differently, to suit my personal needs:
Answer:
Well you just can’t please some people can you! Still TheGigRig Pro-8 is software
upgradeable, so please ring our customer services or send an email and we will
evaluate you requirements. Sales@thegigrig.com