All rights reserved. Design rights claimed. Moral rights asserted. Revised March 2010 Page 9
TheGigRig Pro-8 enables you to choose any combination of these outputs. Simply
mute the output that you don’t want your signal to go to, by turning on the ‘output
mute’.
Note. You should always use output 1 first. Never use output 2 on its own. (Output 1
provides the signal ground; you should only have one signal ground to your system.)
You can have a clean amp in one output and a dirty sounding amp in the other.
Alternatively, if you only use one amp, you can send a line directly to the desk as well
as your amp and then switch between them.
For stage safety, the GigRigs output 2 will also give you and your equipment
protection from over 1000V if a mains fault should occur in the desk electrics.
Idea: Use output 1 for your electric and output 2 for your acoustic sent directly into
the PA system. You can plug your acoustic into RTN of loop 1.
Using combinations of the effects loops and the control functions the possibilities
are virtually endless. And, it all happens at the stomp of a single footswitch.
To Next Page