The Water Well FS-Z03 User Manual (English)

Questions and Answers:

N
Nicholas JonesJul 31, 2025
What to do if both 'Fill Water' and 'Ice Full' lights are on in The Water Well FS-Z03?
- P
  Peggy VillarrealJul 31, 2025
  If both the 'Fill Water' and 'Ice Full' indicator lights are permanently on, it could be due to several reasons: * Ice cubes are stuck in the evaporator panel: Remove the ice cubes, let the ice maker rest briefly, and then restart it. * Too many ice cubes in the storage basket: Remove some ice cubes. * Ice cubes are too large and fused together: Stop the ice maker, pour hot water over the fused ice to melt them, let the ice maker rest with the lid open, and then restart. * The water sensor is too high: Adjust the water sensor to the water inlet tube. If none of these steps work, there may be a fault on the control panel, and you should contact your closest repair centre.
J
johnsonanthonyAug 6, 2025
What to do if there are no lit indicator lights on The Water Well FS-Z03 control panel?
- J
  James Fleming MDAug 6, 2025
  If there are no lit indicator lights on the control panel, check the following: * Ensure the plug is properly connected to the wall socket and that the wall socket is functioning correctly. If the issue persists, the fuse may be blown, and you should contact your closest repair centre.
A
alexandrasmithAug 12, 2025
Why is the 'Fill Water' light always on in my The Water Well Ice Maker?
- T
  Timothy AlexanderAug 12, 2025
  If the 'Fill Water' indicator light is permanently lit, it could be because: * The Water Pump is not working. In this case, contact your closest repair centre. * The Water Pump is only working for 10 seconds then it stops. You should adjust the Water Sensor to the Water Inlet Tube.
T
Terry MurphyAug 18, 2025
What to do if the 'Ice Full' light is on but The Water Well FS-Z03 has few ice cubes?
- A
  Allison HensonAug 18, 2025
  If the 'Ice Full' indicator light is on, but there are only a few ice cubes in the storage basket, the internal temperature of the ice maker might be too low. Open the lid of the ice maker and allow it to stand open for a short period until the indicator light goes off.