The Wings Maker Flyboy 50 - Page 12

LINKAGE CONNECTOR
After fastening the round nut, make sure that the linkage connector can rotate freely.
Drill 2mm hole at servo horn.
Insert linkage connector
into servo horn.
Make sure shoulder of
screw is cleared from
servo horn.
Add washer to reduce
play if necessary.
Shoulder
Tighten up the round nut
against the shoulder. Apply
CA or permanent thread
locker.
www. thewingsmaker. com
THE WINGS MAKER
GA014PO28971303
All manuals and user guides at all-guides.com