Therabath TB5 - Page 3

• 3 / 12 •
Operating Instructions
1. Unpack the unit and place it on a at, secure
surface.
2. Open the 6 bags of paran and place the
contents inside the tank.
3. Place the plastic grille on TOP of the UNMELTED
paran.
4. Rest the lid on top of the paran and grille. The
paran will compact as it melts.
5. Plug the unit in.
6. The paran will melt in about 8 to 10 hours.
7. Keep the unit plugged in all the time so it is
ready for use.
AddingRellParan
1. Keep the paran level in between the lines (on the inside
of the tank).
2. Use only Therabath
®
brand paran in this unit. Other types
of paran may cause improper operation or damage,
and will void the warranty.
3. Do not overll the unit.
TreatmentGuidelines
• Cleanse and dry the skin before applying paran.
• Keep clothing and jewelry away from the treatment area.
• Do not remelt used paran. Discard used paran.
• Keep the lid on when unit is not in use.
• Refer to contraindications before use.
1. Apply Sanitizing Spray.
††
(Do not use spray near the eyes, nose, or mouth.)
2. Apply Hydrating Cream.
††
3. Slowly dip hand, foot, elbow, or other treatment area into the paran.
4. Remove and wait a few seconds. Repeat 3 to 10 times.
5. Cover hand or foot with a plastic liner.
††
6. Slip on an insulated mitt or boot to retain heat.
††
7. Keep paran in place for 10 to 15 minutes.
8. Remove. Discard used paran and plastic liner (if used).
††
OPTIONAL: Sanitizing Spray, Hydrating Cream, plastic liners, mitts, boots, and
more are sold separately. Call your dealer or WR Medical Electronics: www.
therabath.com.
CleaningInstructions
• Clean the unit after every 40 treatments, when the paran is no longer clear, or whenever
sediment accumulates on the bottom.
• Do not scratch or damage the inside tank coating.
• Do not immerse the unit in water.
• Do not use abrasive scouring powders of any kind when cleaning the tank.
1. Unplug the unit. Remove the grille. Allow the paran to solidify.
2. After the paran is solid, plug the unit in until the paran loosens from the tank. Unplug
the unit.
3. Push down rmly on one end of the paran to tilt the opposite end up. Lift out the cake
and dispose. Do not use sharp objects.
4. Remove remaining paran in the tank with soft paper towels.
5. Clean the inside and outside with an all-purpose cleaner. Wipe dry.
6. Rell with Therabath
®
brand paran.