14
Using detergents with salt component
Detergent with a salt component
If combined detergents with a salt component are used,
special salt can usually be omitted up to a water
hardness of 21° dH (37° fH, 26° Clarke, 3.7 mmol/l). If
the water hardness is over 21° dH, salt must be used.
Switching off low salt indicator / water
softening system
Switching off water softening system
If the use of combined detergents with a salt component
impairs the low salt indicator on the digital display
H,
the low salt indicator can be switched off.
Proceed as described under “Setting water softening
system” and set the value to
•:‹‹. The water softening
system and salt refill indicator are now switched off.
To Next Page
Loading...
