Installation Insert
GUIDE
IMPORTANT: This insert is in addition to the Installation Guide and is not a substitute. Read and consult the appliance
Installation Guide for important safety messages and additional information regarding the use of your new appliance.
Professional and Masterpiece
®
Combination Built In Ovens
POM301W, PODMC301W, PODMCW31W,
MEM301WS, MEDMC301WS, MEDMCW31WS
9
Mounting the Speed Oven or
Microwave to the Lower Oven
Parts Provided
Universal connector
bracket (2)--in parts box
on top of oven
Screws (16)--in red bag
inside parts box on top
of oven.
Oven Mounting Screws
(8)--screws are included
to secure the oven trim
to the cabinet. The
screws are located in a
small plastic bag affixed
to the literature pack
bag.
Trim Piece--in plastic
bag on top of oven.
Pre-Assembly of the Combination Oven
Combination ovens require the two components to be
assembled prior to installing the combination unit into the
wall cabinet.
Note:
The installation procedures differ between the
microwave and speed oven combination units. The parts
contained in the square tube parts box are common to all
installations.
•
Do not place the oven into the wall cabinet until after
mounting the speed oven on top of the lower oven and
securing it with the universal connector brackets.
•
The universal connector brackets are interchangeable
for the left and right sides of the oven. Be sure the taller
vertical edge of the bracket is positioned to the outside
of the oven.
1. Install both universal connector brackets on top of the
lower oven using six (6) of the screws provided.
Tighten screws securely, but do not overtighten.
2.
Insta ll decorative trim.
Position the decorative
trim piece so the flanges
with the holes in them
face to the rear of the
oven.
To Next Page
Need help?
General
