WARNINGS
Read and understand this entire Manual and your employer's safety practices before
installing, operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best judge-
ment, the Manufacturer assumes no liability for its use.
Plasma Cutting Power Supply, Auto-Cut
®
200
Operating Manual No. 0-4805
Published by:
Victor Technologies
16052 Swingley Ridge Road, Suite 300
Chersterfield, MO 63017
636-728-3000
www.thermal-dynamics.com
© Copyright 2005, 2006, 2007,2008, 2009, 2010, 2011, 2012, 2013
by
Victor Technologies
All rights reserved.
Reproduction of this work, in whole or in part, without written per-
mission of the publisher is prohibited.
The publisher does not assume and hereby disclaims any liability to
any party for any loss or damage caused by any error or omission
in this Manual, whether such error results from negligence, acci-
dent, or any other cause.
Publication Date: October 7, 2005
Revision Date: January 8, 2013
Record the following information for Warranty purposes:
Where Purchased: ___________________________________
Purchase Date:______________________________________
Power Supply Serial #:_______________________________
Torch Serial #:_______________________________________
To Next Page
Loading...
Need help?
General
