NOTE
THERMITRON device works automatically by turning the water on and off.
However, if after each use you first set the switch to position OFF and then turn off the water, you will
achieve something very important. You will avoid the accumulation of salts in the chamber of the device for
many years, helping in its longevity.
HANDLING - TEMPERATURE SETTING
Set the switches to HIGH position and turn on water until LED lights up (ON MINIMUM WATER QUANTITY
WHICH ACTIVATES THE DEVICE). After 8-10 seconds, you will note that the water is hot, with a constant
temperature. If you would like it more lukewarm, just slightly increase the flow.
When the weather is warm (SUMMER), use positions MED or LOW, always repeating the same setting
process.
NOTE:
a. GREATER WATER FLOW - LOWER TEMPERATURE
b. SMALLER WATER FLOW - HIGHER TEMPERATURE
HIGH POSITION = WINTER
MED POSITION = SUMMER
LOW POSITION = SUMMER
OFF POSITION = DOES NOT OPERATE
FOR MORE HOT WATER DURING SUMMER, REPLACE THE MIDDLE RING OF THE SHOWER
DIFFUSER WITH THE CORRESPONDING ONE WHICH IS IN THE BAG.
TECHNICAL DATA TABLE
USEFUL INFORMATION
• In order to ensure proper operation of your device, you must keep it free of rubbish and salts with natural
cleaning.
• If LED is not lit when turning on water, this means that the water supply pressure is very low.
• If LED lights up but the there is no hot water, you will have to contact the maintenance service
department of THERMITRON.
• Any unauthorized modification or action contrary to the instructions and installation guide can be the
reason for malfunction or even damage.
• If the device is installed in an area where water freezes in the winter, it is necessary to empty any
remaining water by loosening the cold water outlet.
To Previous Page
Loading...