Operating Instructions
90
Language Menu Quick Access
Should it be necessary at any time to change to English or any
other installed language, return to the Standard Display and
then press and hold the first and last soft keys for 5 seconds as
shown below. The Standard Display shown in Figure 100 is
Español (Spanish).
Figure 100: Standard Display in Español
After 5 seconds the Language Menu will appear in the current
language as shown below. Press the + or - Keys to select the
desired language. When the desired language is shown press
the SI (YES) Key to confirm the choice (Figure 101).
Figure 101: Select Desired Language
NOTE: All languages in the installed software can be
selected using this method.
Alarms
The Alarm Menu allows the operator to view any active
alarms, and allows most alarms to be cleared.
Log Alarms
If only Log Alarms exist the display shown in Figure 102 will
appear and the optional remote alarm light will light for 30
seconds when the unit is turned on.
To Next Page
Loading...
Need help?
General
