Thermo Scientific E-pure 1090 Series User Manual (English)

Questions and Answers:

L
Larry KirkAug 9, 2025
What to do if my Thermo Scientific Water Filtration System pump does not run but the display lights?
- A
  Anthony WilliamsAug 9, 2025
  If the pump of your Thermo Scientific Water Filtration System isn't running but the display lights are on, here's what you can check: * Ensure the pump protector, feedwater line pressure switch, or jumper plug is correctly connected to the pump module receptacle on the left side of the pump housing. If using a Thermo Scientific pressure switch in the feedwater line, the pump needs a pressure of 0.35 kg/cm2 (5 psi) to start. * Make sure the feedwater line shutoff valve is open or that the feedwater reservoir is full. * If you're not using a pump protector, verify that a jumper plug is installed.
J
Jason WagnerAug 14, 2025
Why is my Thermo Scientific Water Filtration System recirculated water not reaching the desired purity level?
- S
  steven95Aug 14, 2025
  If the recirculated water in your Thermo Scientific Water Filtration System isn't reaching the desired purity, it could be due to several reasons: * The cartridges may be exhausted and need replacement. * The cartridges might be out of order; ensure they are installed correctly. * The cartridges could be upside down; install them right side up. * The feedwater might be bypassing the cartridge; check the small O-ring inside the head for damage and proper installation.
A
Andrea HarrisAug 19, 2025
How to fix leaking canisters in my Thermo Scientific Water Filtration System?
- P
  pwardSep 12, 2025
  If the canisters in your Thermo Scientific Water Filtration System are leaking, the large O-ring on the cartridge holder might be missing, damaged, or improperly installed. Replace the O-ring or position it correctly to resolve the leak.
A
Angela HernandezAug 25, 2025
Why is my Thermo Scientific Water Filtration System cartridge life so short?
- E
  Eric FernandezAug 26, 2025
  If you're experiencing short cartridge life with your Thermo Scientific Water Filtration System, consider the following: 1. Check the expiration date of the cartridges. They lose capacity after two years from the manufacture date; replace them if expired. 2. If using a Thermo Scientific ROpure as a feedwater source, verify the membrane is functioning correctly. 3. For a Thermo Scientific Still feedwater source, ensure the distillate temperature to the E-pure doesn't exceed 49°C (120°F). 4. If using tap water, check its quality, as it can change seasonally. 5. If the feedwater comes from a central water purification system, verify its water quality and proper functioning.
G
Grace WebsterAug 29, 2025
What to do if my Thermo Scientific E-pure Water Filtration System is completely inactive?
- D
  Dr. Robert Jackson MDAug 29, 2025
  If your Thermo Scientific E-pure Water Filtration System is completely inactive, with the pump not operating, check these two things: * Ensure the power cord is connected to a live power source and fully plugged into the outlet. * Replace the main fuse.
R
Rebekah DoyleSep 3, 2025
What to do if my Thermo Scientific Water Filtration System has reduced or no product flow?
- S
  seantaylorSep 3, 2025
  If your Thermo Scientific Water Filtration System has reduced or no product flow, the final filter may be clogged. Replace the final filter.