C-Link Protocol Commands
Measurements
B-8 Model 49i Primary Standard Instruction Manual Thermo Fisher Scientific
Measurements avg time
high avg time
low avg time
These commands report the averaging time in seconds when operating in
single range, or averaging time used with the high and low ranges when
operating in dual or auto range mode. The example that follows shows that
the averaging time is 300 seconds, according to Table B-2.
Send: avg time
range mode Reports/sets current range mode B-31
relay Reports/sets relay logic status of designated relay(s) B-43
relay stat Reports/sets relay logic status of designated relay(s) B-43
resp coef Reports/sets the current O
3
response coefficient B-25
ri (right) Simulates pressing right pushbutton B-28
ru (run) Simulates pressing run pushbutton B-28
sample Sets zero/span valves to sample mode B-31
save Stores parameters in FLASH B-35
save params Stores parameters in FLASH B-35
sc (screen) C-series legacy command that reports a generic response (Use
iscreen instead)
B-29
sp conc Reports/sets the span concentration for autocalibration B-27
sp field Reports/sets item number and name in scratch pad list B-23
span Sets zero/span valves to span mode B-31
sr Reports last short record stored B-18
srec Reports maximum number of short records B-19
srec f
ormat Reports/sets output format for short records (ASCII or binary) B-20
srec layout Reports current layout of short record data B-21
srec mem size Reports maximum number of short records B-21
srec per Reports/sets short record logging period B-22
stream per Reports/sets current set time interval for streaming data B-24
stream time Reports/sets a time stamp to streaming data or not B-24
temp comp Reports/sets temperature compensation on or off B-33
time Reports/sets current time (24-hour time) B-35
up Simulates pressing up pushbutton B-28
zero Sets zero/span valves to zero mode B-31
Table B-1. C-Link Protocol Commands, continued
Command Description Page
To Next Page
Loading...
