REC 3838 2-3
2.5 EQUIPMENT LOCATION
Careful consideration should be given to the location of the electronics, as system
performance is affected by its location. The following requirements must be followed.
1. The electronics should be located so maintenance personnel can easily perform
cleaning and adjustment procedures, and so both the control panel and electronics
enclosure rear doors are easily accessible. This requires clear space behind and in
front of the machine.
2. There should be a minimum of vibration in the area. Vibrations can be conducted to
a loadcell and affect weighing accuracy.
3. The electronics system is designed to operate in an environment where the
temperature ranges no lower than -14° F (-10° C) nor higher than 122° F (50° C).
4. The electronics will operate in an environment where the humidity (non-condensing)
ranges from 0% to 95%.
To Next Page
Loading...