15
Quick-disconnect terminal block (C-Q drives only)
The quick-disconnect terminal block, found only on C-Q drives, is
composed of a 9-pin header block and 9-screw terminal plug
(Figure 8). To use the quick-disconnect terminal block:
1. Carefully pull terminal plug from header block.
2. With a small flat-head screwdriver, turn terminal plug screw
counterclockwise to open wire clamp.
3. Insert stripped wire into the large opening in front of the plug.
4. Turn the terminal plug screw clockwise to clamp the wire.
5. Repeat steps 2–4 for each terminal until all connections are
made. Make no connections to F1 and F2 if using a permanent
magnet motor.
6. Insert plug into header until securely fastened.
Figure 9. Quick-Disconnect Terminal Block
Header Block
(mounted on the drive)
Terminal Plug
Installation
To Next Page
Loading...