47
ACCELERATION (ACCEL)
The ACCEL setting determines the time the motor takes
to ramp to a higher speed. See Specifications on page 1 for
approximate acceleration times. ACCEL is factory set for the
fastest acceleration time (full CCW).
To set the acceleration time:
1. Set the speed adjust potentiometer full CCW. The motor
should run at minimum speed.
2. Turn the speed adjust potentiometer full CW and measure
the time it takes the motor to go from minimum to
maximum speed.
3. If the time measured in step 2 is not the desired acceleration
time, turn the ACCEL trimpot CW for a slower acceleration
time, or CCW for a faster acceleration time. Repeat steps 1
through 3 until the acceleration time is correct.
Calibration
To Next Page
Loading...