Thermo Scientific NanoDrop One User Guide 155
Measure Kinetics
Measure Kinetics
The NanoDrop One
C
model instrument can be used to make time-based kinetic
measurements on samples in cuvettes. Up to 3 wavelengths between 190 nm and 850 nm can
be designated for continuous absorbance monitoring at user-defined intervals in up to
5 stages. Cuvette measurements offer an extended lower detection limit and an optional 37 °C
heater and micro-stirrer.
To make kinetic measurements
Make time-based kinetic
measurements using the cuvette
holder (NanoDrop One
C
model
instruments only).
Measure Kinetics
Create Kinetics Method
Edit Kinetics Method
Reported Results
Settings
Detection Limits
Note The instrument arm can be up during cuvette measurements, which allows you to
add reagents to the sample solution if desired.
NOTICE
• To prevent damage from spills, keep containers of liquids away from the instrument.
• Do not use a squirt or spray bottle on or near the instrument as liquids will flow into
the instrument and may cause permanent damage.
To Next Page
Loading...
