Measure Kinetics
Thermo Scientific NanoDrop One User Guide 159
–tap Stages and Intervals tab (the stages and intervals settings are displayed)
–select Number of stages and Time unit (minutes or seconds)
– for each stage, specify # intervals, Interval times and any Delays between stages
The colored rows and boxes at the right visually represent the specified stages. The
colored rows show the start and end times for each stage; the colored boxes
correspond with the specified delay and number of intervals for each stage.
– to save the method and return to the Kinetics menu, tap Save Method
– to run the method, tap Run Method
Related Topics
• Edit Kinetics Method
Edit Kinetics Method
Kinetics methods can be edited only on the NanoDrop One instrument. To edit an existing
kinetics method:
– if the instrument has a connected PC (Ethernet or Wi-Fi), make sure Data Storage is
set to the correct location for the kinetics method you want to edit
Note The method is saved in the currently selected Data Storage Location (local
instrument or a connected PC).
To Next Page
Loading...
