Serial Communications 3104
REC XXXXX 2-3
-SLOT # N CHANGED
Acquire new
configuration?
YES NO
Figure 2-2 Micro-Tech 3000 Mother Board
EXPANSION
SLOT
6. Insert the hex head screw through the chassis and tighten.
7. Install the wired mating connector on the COMM board connector.
8. Reinstall panel mount enclosure in the panel.
9. Turn power back on. The following screen appears when power is applied
and remains on for 10 seconds.
The screen disappears after 10 seconds if the question is not answered, and
the Micro-Tech 3104 assumes the answer is NO. "HW CONFIG. CHANGED"
alarm is on and cannot be reset. The above screen appears each time power
is cycled if the question is not answered.
Answer YES because this is a hardware configuration change.
10. This completes the installation procedure.
11. Set-up data for the newly installed COMM board must now be
entered. Proceed to Chapter 3.0, Operation.
To Next Page
Loading...