manual storage ut5 2022 12 v.3.
i n d d
13
Unit size (Ut5 / Ut5 Combi)
G3/8 G3/8
Unit size (Ot5 / Ot5 Combi)
G1/2 G1/2
The unit must
be
filled with water before connecting it to the power supply!
When switching on for the first time, make sure that the temperature indicator (LED) goes out when the
desired temperature is reached (the appliance has reached the set temperature). The unit
will not switch
on again until the temperature drops below this setting. (See Troubleshooting)
When filling for the first time, the hot water valve in the low-pressure fitting must be open so that
water can flow into the appliance. If the appliance is not filled with water before installation,
the automatic
safety device is activated and the appliance is switched off. (See Troubleshooting instructions on
what to do in the event of a fault).
To Next Page
Loading...