Thermopatch provides this HS3E and HS4E Quick Start Guide for the
convenience of its customers. For optional settings, complete maintenance
instructions and troubleshooting information, refer to the instruction manual
provided. Thermopatch recommends the complete reading of the HS3E-4E
Instruction Manual by machine operators prior to use or undertaking any
maintenance activities. For questions or comments, contact your Thermopatch
representative at http://www.thermopatch.com or sales@thermopatch.com.
6
Maintenance
7
Customer Service
Teon Cover
Clean the Teon cover frequently by wiping with a soft clean
rag often to remove adhesive. Never use a ammable
solvent or abrasive cleaner. Replace the Teon cover
whenever it becomes torn or too soiled to clean (see Manual
for replacement instructions). The Teon cover must be
replaced when buildup occurs.
Lower Press Platen
Clean often by wiping with a soft, clean rag. Replace the pad
whenever it becomes deteriorated (see Manual for
replacement instructions).
Lubrication
The HS3E and HS4E machines do not require lubrication.
Thermopatch Corporation’s international network of sales
representatives, as well as its internal Customer Service
Department, offer their assistance in the development of
effective heat-seal mending, marking, and identication
programs.
Thermopatch markets a complete line of heat-seal and marking
machines, as well as a complete line of materials and supplies.
When ordering machine parts, please include the model
number and serial number of the equipment.
47244-INSTR
To Next Page
Need help?
General
