Thermoplan Black&Whute3 CT - Machine Chassis Components and Views; Chassis Error Messages

REV-1
6.14
© 2011 by Thermoplan AG, Änderungen vorbehalten
SECTION 6
Technical manual
4.1 Error messages Chassis
4. Chassis
Error no. / picture Text Cause Fix
TX0104 Empty grounds drawer - Grounds drawer full
- No magnet on grounds drawer
- Magnet switch on chassis
defective
- Cable between magnet switch and
CPU has short circuit
- Remove grounds drawer, empty,
reinsert (wait min. 5 seconds)
- Mount magnet again
- Replace magnet switch
- Check cable and replace if
necessary
TX0106
Grounds drawer missing - Grounds drawer not inserted
correctly
- No magnet on grounds drawer
- Magnet switch on chassis
defective
- Cable between magnet switch and
CPU has short circuit
- Remove grounds drawer, empty,
reinsert (wait min. 5 seconds)
- Mount magnet again
- Replace magnet switch
- Check cable and replace if
necessary
TX0108
Service required Amount of brew cycles programmed
into machine has been reached
Provide annual service on machine.
Reset counter in service menu „Sta-
tistics“, to delete message. Machine
starts counter again from 0.
TX0109
Clean appliance Since the rst product dispensing
48 hours have passed (coffee pro-
ducts only) or 24 hours have passed
(if milk products were dispensed).
Machine must be cleaned to unlock.
Clean machine
TX0110
Voltage low Voltage too low, operation is
stopped as soon as voltage is below
the set tolerance (adjustable from
0-30%).
If the voltage gets too low during
a product dispensing, the product
will be nished, then the operation
stops.
Wait until voltage stabilises
TX0111
Voltage high Voltage too high, operation is
stopped as soon as voltage is above
the set tolerance (adjustable from
0-30%).
If the voltage gets too high during
a product dispensing, the product
will be nished, then the operation
stops.
Wait until voltage stabilises
TX0113
Piston error - Brew cylinder cannot travel to
desired position
- The gear belt between motor and
drive screw of the brew cylinder
is defective or not mounted
- The way of the brew cylinder is
blocked
- The mobile piston is blocked and
the brew cylinder cannot travel
back to the micro switch
- The brew cylinder cannot travel
over the x piston.
- Try dispensing product again
- Perform a rinse
- Check mechanical module
- gear belt
- brew cylinder
- mobile piston
- micro switch
- x piston