Thermoplan Black&Whute3 CT - Hydraulic Module Diagnostics and Components; Hydraulic Module Error Messages

REV-1
6.36
© 2011 by Thermoplan AG, Änderungen vorbehalten
SECTION 6
Technical manual
6.1 Error messages Hydraulic module
6 Hydraulic module
Error no. / picture Text Cause Fix
TX0101 NTC coffeeboiler open Problem with NTC in coffee boiler Check NTC and if necessary
exchange
TX0115
Flow error Too low water ow 1. Open mains water connection
2. Empty grounds drawer
3. Perform rinse
4. Check owmeter
5. Check pump
TX0116
Overtime error Product is not dispensed correctly
because of too low water ow
1. Dispense product again
2. Check owmeter
3. Check pump
TX0125
Waterow error No water pressure or owmeter
defective
1. Open mains water connection
2. Empty grounds drawer
3. Perform rinse
4. Check owmeter
5. Check pump
TX0141
NTC coffee boiler short-circuit NTC on coffee boiler had a short
circuit
Change NTC on coffee boiler
TX0151
No waterow detected No water pressure or owmeter
defective
1. Open mains water connection
2. Empty grounds drawer
3. Perform rinse
4. Check owmeter
5. Check pump
TX0154
Milk pump: no pulse Milk pump not recognised
TX0155
Water pump: no pulse Milk pump not recognised
TX0161
Please wait Machine rinses Wait until rinse is nished
TX0201
Cold start rinse
Please press rinse key
Rinse for start- and warm-up of
machine
Press rinse key