Thiel CS 3.5 Unpacking Instructions

UNPACKING
INSTRUCTIONS
ON OTHER
SIDE
THIEL
CS3.5 REPACKING
INSTRUCTIONS
lf it is necessary
to
repack
the
speakers, it must
be done
properly
to avoid
damage
during
shipping.
1.
Unmount
trim strip
on
front
of
speaker.
Remove
grille
frame
by
pulling
its
bottom
away
from
the cabinet about
a
haltinch
and
then
lifting
it
upward
(reverse
order of
the
installation
illustrated
on the other side). Reinstalltrim
strip.
2. Tape
orange tweeter
protector
cap over
tweeter and
cover speaker with
plastic
bag if
available.
3.
Place
empty carton
over speaker
and
insert
the two long
cardboard
corners
at back
of
speaker. Lay
speaker
(in
carton) on
its
back.
4. Mount
grille
to large
plywood piece
by
inserting
grille
bottom edge into
slot in foam
and
grille plastic
fasteners
into holes near
top.
Insert
plywood
(with
grille
mounted),
with
narrow
side of
grille
first,
from
top of
carton.
lt is
helpfulto have
a second
person
who
can
guide
this
piece
from
the bottom
of speaker
over the trim
strip and
into
proper position
with foam
against
speaker
front.
5.
lnstall
bottom
plywood
and
cardboard
pad
assembly into
bottom of
carton
so that
the
cardboard blocks
run side
to side. Close
all
four
carton
flaps
and tape or
staple
securely.
6. Stand speaker
upright
and
installthe
top
plywood
and
foam
pad
assembly making
sure that
speaker is
held
toward
back
of carton by lip
on
the
foam
and
that the
front
plywood piece
is
outside of
foam lip
on
bottom of
top
plywood
piece.
lsn't
this
confusing?
See illustration.
7.
Close
all
four
top cardboard
flaps
and tape
or staple
securely.
RIGHT
FOAM
PADS
\,.,
PLYWOOD
WRONG
GRILLE
SPEAKER

Thiel CS 3.5 Specifications

General

Brand	Thiel
Model	CS 3.5
Category	Speaker System
Language	English